| Permit | Form: (06)
404381315
11/06/2025 | "As-Drilled" well location GPS data has not been reported for this well.
Operator will obtain the GPS data pursuant to Rule 216 and submit it on the Form 6 Subsequent Report of Abandonment. |
| OGLA | Form: (06)
404381315
11/10/2025 | Operator committed to the following Best Management Practices under the Technical Detail/ Comments section on the Submit Tab. Operator will use secondary containment for all tanks and other liquid containment. |
| Engineer | Form: (06)
404381315
11/10/2025 | 1) Provide electronic Form 42 Notice of MIRU 2 business days ahead of operations and electronic Form 42 Notice of Plugging Operations 48 hours prior to mobilizing for plugging operations. These are two separate notifications, required by Rules 405.e and 405.l.
2) Pump surface casing shoe plug at 1900' only after isolation has been verified. If surface casing cement is not circulated to surface, shut-in, WOC 4 hours then tag plug – must be at 164' or shallower and provide a minimum of 10 sx plug at the surface.
3) Leave at least 100’ of cement in the wellbore for each plug without mechanical isolation.
4) After cut and prior to cap, verify isolation by either a 15 minute bubble test or 15 minute optical gas imaging recording. If there is indication of flow contact ECMC Engineering. Provide a statement on the 6SRA which method was used and what was observed. Retain records of final isolation test for 5 years.
5) With the Form 6 SRA operator must provide written documentation which positively affirms each COA listed above has been addressed. |
| Engineer | Form: (06)
404381315
11/10/2025 | Operator shall implement measures to control venting, to protect health and safety, and to ensure that vapors and odors from well plugging operations do not constitute a nuisance or hazard to public welfare. |