<_x0034_01135736>

401135736 02 2016-12-20T14:50:24.91-07:00 10311 SYNERGY RESOURCES CORPORATION

20203 HIGHWAY 60

PLATTEVILLE CO 80651 Erin Ekblad 720 616.4319 720 616.4301 Erin Ekblad Manager Regulatory Affair 2016-12-20T14:50:24.91-07:00 2016-12-20T14:50:24.44-07:00 UPLOADED eekblad 2016-10-24T09:16:57.78-06:00 eekblad eekblad@syrginfo.com 3.00000 false eekblad@syrginfo.com bauerc bauerc 2017-01-04T12:09:35.37-07:00 401135736 DR N N OIL SINGLE N Goetzel 32C-30-M 15469 SWNE 29 6N 66W 6 2446 WATTENBERG FEL 2073 90750 4728 FNL WELD HORIZONTAL 2577 510 FWL FEE 2278 FNL 29 FEE 6N 66W 240 W2NE, W2SE, E2SW Section 29 T6NR66W FWL 2303 0 FNL 30 200 6N 66W FEET FEET N N N Y OFFSITE Commercial Disposal 20090043 ANNULAR PREVENTOR DOUBLE RAM 40.460624 -104.801188 2016-07-07T00:00:00-06:00 Rob Wilson 1.2 true false true false false false false false false false false true true false false FEE true oil and gas lease 510 FEET 29: S2NW, SWNE, N2SW, NWSE, 30: S2N2, N2S2 6N66W 222 FEET true 318A OFFSITE Commercial Disposal false false false false false false false true true false false false mpatel@syrginfo.com false false 401135736 Surface Use Agreement has waivers for Rule 318A.a & 318A.c. See page 5, Section 9 (a). Drilling tab, 222 feet to miller 2 using anti-collision report. Spacing tab, distance proposed wellbore to offset same formation is 200 feet to Goetzel 32N-30C-M using plan view map measurement. 401135736 401135736 FORM 2 SUBMITTED 401135736.pdf 401135736 401135737 SURFACE AGRMT/SURETY Goetzel - SUA (North).pdf 2976110 401135736 401135758 WELL LOCATION PLAT GOETZEL 32C-30-M_WELL_CERTIFICATE_20161010.pdf 208968 401135736 401160326 DEVIATED DRILLING PLAN GOETZEL 32C-30-M WELL PLAN (REV-A.0, 11-15-16).pdf 621923 401135736 401160327 DIRECTIONAL DATA GOETZEL 32C-30-M PWP (REV-A.0) REPORT.xlsm 32586 401135736 401171114 OffsetWellEvaluations Data MH Goetzel 7-29 Offset Mitigation 12-19.xlsx 36508 401135736 401171115 OFFSET WELL EVALUATION MH Goetzel 7-29 Offset Mitigation 12-19.pdf 246416 401135736 401171116 EXCEPTION LOC REQUEST Goetzel 7-29 Pad 318 A.a. & 318A.c. Exception Twinning Location.pdf 306642 401135736 401171117 MINERAL LEASE MAP Goetzel 32C-30-M.pdf 295169 401135736 401171119 PROPOSED SPACING UNIT Goetzel 32C-30-M Proposed Spacing Unit Letter.pdf 473170 401135736 401129755 02A dad3f366-fb23-410e-b7de-69beb8f8751c 401135736 3 Emissions mitigation Emissions Mitigation: 604.c.(2)C.i. Green Completions - Emission Control System: Test separators and associated flow lines and sand traps shall be installed on-site to accommodate green completions techniques pursuant to COGCC Rules. The flowback gas shall be sold or shall be captured and combusted with an Emissions Control Device (ECD), which will be installed and kept in operable condition for least the first 90-days of production pursuant to CDPHE rules. This ECD shall have an adequate capacity for 1.5 times the largest flowback within a 10 mile radius, and will be piped to other or permanent equipment and shall be provided with the equipment needed to maintain combustions where non-combustible gases are present. There is a sales line available, Synergy plans to turns to sales as soon as possible. false 903e2004-83dc-4ca9-80ac-417b60ec9a70 401135736 7 Drilling/Completion Operations Drilling/Completion Operations: 604.c.(2)B.i Operator will be utilizing a closed loop system. false 1802dd9f-3ea8-4eee-aed8-48163d2c1154 401135736 5 Drilling/Completion Operations Drilling/Completion Operations: 604.c.(2)L. Closed chamber drill stem tests shall be allowed. All other drill stem tests shall require approval by the Director. None planned for this well. false 23741991-cc26-4ff6-9944-79eb8c63cf55 401135736 10 Drilling/Completion Operations Anti-collision: Operator will perform an anti-collision evaluation of all active (producing, shut in, or temporarily abandoned) offset wellbores that have the potential of being within 150 feet of a proposed well prior to drilling operations for the proposed well. Notice shall be given to all offset operators prior to drilling. false e32cc30b-9a35-4430-a990-2e49a62f8302 401135736 1 Planning 604.c.(2)J.i Blowout Prevention Equipment (“BOPE”): A double ram and annular preventer will be used during drilling. Stabbing valves shall be installed in the event of reverse circulation and shall be prior tested with low and high pressure fluid. false 737c0511-1860-4955-a08f-7acf9d3ddb97 401135736 8 Drilling/Completion Operations Requirement to log well. 317.p For all new drilling operations, the operator shall be required to run a minimum of a resistivity log with gamma-ray or other petrophysical log(s) approved by the Director that adequately describe the stratigraphy of the wellbore. A cement bond log shall be run on all production casing or, in the case of a production liner, the intermediate casing, when these casing strings are run. These logs and all other logs run shall be submitted with the Drilling Completion Report, Form 5. Open-hole logs or equivalent cased-hole logs shall be run at depths that adequately verify the setting depth of surface casing and any aquifer coverage. These requirements shall not apply to unlogged open-hole completion intervals. false 6318cbef-b9bd-4fc1-b43f-9689d62be694 401135736 2 Planning 604.c.(2)J.ii Backup stabbing valves be required on well servicing operations during reverse circulation. Valves shall be pressure tested before each well servicing operation using both low-pressure air and high-pressure fluid. false 8b0c68c6-f37f-40e5-a7a5-eb0f25650aff 401135736 9 Drilling/Completion Operations Operator will comply with COGCC policy for Bradenhead Monitoring During Hydraulic Fracturing Treatments in the Greater Wattenberg area dated May 29, 2012. false 2c0de847-fbf0-43a8-a579-ebc284a736d4 401135736 4 Drilling/Completion Operations Drilling/Completions Operations: RULE 604.c.I: Upon initial rig-up and at least once every thirty (30) days during drilling operations thereafter, pressure testing of the casing string and each component of the blowout prevention equipment including flange connections shall be performed to seventy percent (70%) of working pressure or seventy percent (70%) of the internal yield of casing, whichever is less. Pressure testing shall be conducted and the documented results shall be retained by the operator for inspection by the Director for a period of one (1) year. Activation of the pipe rams for function testing shall be conducted on a daily basis when practicable. false 71e24f7c-80f7-48db-bc0f-bdd7c516b233 401135736 6 Drilling/Completion Operations Drilling/Completion Operations; 604.c.(2).O. Drilling and Completion-All loadlines shall be bullplugged or capped. false 401135736 1ST 8 1 2 5 1 2 17 15469 1932 15469 0 0 PLANNED 401135736 CONDUCTOR 24 16 65 40 70 40 0 0 PLANNED 401135736 SURF 13 1 2 9 5 8 36 1700 464 1700 0 0 PLANNED 401135736 CODELL CODL 600 GWA Thread was being aborted.